THE PROBLEM
The stock center support bearing carrier holds the driveshaft in place with a layer of thin rubber. While that’s great for making sure no NVH makes it to the cabin, it doesn’t keep the bearing centered well under load, allows the bearing to sag over time and ruin the driveshaft alignment, and creates slop in the driveline during shifts and throttle application. Over time the OEM bushing sags and becomes brittle, eventually dry rotting and cracking. Even on the best-kept cars, the stock bushing can start to form cracks in as little as 5-10 years. When the bushing lets go, it puts more stress on the shaft and leads to excessive vibration and clunking. To make matters worse, the stock carrier is molded onto the center support bearing, so it’s not easy to replace without special tools.
THE SOLUTION
This upgraded unit keeps the driveshaft firmly in place at all times, and its solid construction ensures it will never sag or crack over time. The thick bushings ensure the driveshaft cannot move from center, maintaining driveshaft alignment at all times.
Two options are available for the bushings, both of which are many times over better than the stock bushing. We’ve paid close attention to the NVH levels associated with this upgrade. After extensive design iterations, we’ve come up with custom isolator bushings that separate the carrier from the body of the vehicle and mounting hardware. These carriers substantially reduce NVH levels.
The street bushings absorb most of the NVH from the drivetrain. Some light NVH is possible at some speeds in the form of a soft hum. With a modified exhaust or windows down you’ll probably never hear it.
The track bushings are for those who want no-compromise drivetrain performance. These may create a substantial amount of cabin noise. Not sure which is for you? They’re interchangeable so you can try them both.
Installation doesn’t require removal of the driveshaft. The 2-part design clamps around the OEM bearing. The old carrier must be removed, so a cutting tool is required. The exact steps to access the carrier will vary slightly by model, but the removal and installation of the new carrier are the same. The basic steps are:
-
Remove any braces or splash shields preventing exhaust and heat shield removal
-
Remove or lower exhaust in area of center support bearing
-
Remove heat shielding covering center support bearing
-
Cut off OEM carrier and remove rubber support material with razorblade, leaving base layer of rubber intact on the bearing
-
Clamp new carrier around OEM bearing
![Yukon Gear Ring and Pinion Set [For Camaro Diff]](https://g8only.com/wp-content/uploads/2023/08/yukon_maro.jpg.webp)
Arrived on time, quality part, great fit, back on the road.
easy install major upgrade
Very easy to install, all around great product! Must need upgrade!
Easy install and no problems
Fit and finish of this product is excellent. Install was super easy and straightforward. This company knocked it out of the park with this one.